Macrowine 2021
IVES 9 IVES Conference Series 9 Mouthfeel effects due to oligosaccharides within a wine matrix

Mouthfeel effects due to oligosaccharides within a wine matrix

Abstract

The mouthfeel of wine is one of the most important aspects of the organoleptic experience of tasting wine. In wine a great deal is known about certain compositional components and how they impact mouthfeel perception, such as phenolics. But there are other components where little is understood, such as oligosaccharides. Saccharides in general are found in very low concentrations with wine, especially compared to conventional foods. There is very little information about how oligosaccharides influence the mouthfeel perception of wine. Given the large variance in types and concentrations of oligosaccharides present within the wine system this study aimed to understand their effects with as little variables as possible. This study utilized two different types of oligosaccharides at two different concentration levels to identify and quantify differences in mouthfeel perception within a model wine system. The two oligosaccharides in question, Fructooligosaccharide (FOS) and Glactooligosaccharide (GOS), were added to a basic wine model (14% ethanol, 4 g/L tartaric acid, pH 3.5) at a rate of 450ppm and 900ppm. Concentrations that have been measured in wine, resulting in four treatment groups, FOS450, FOS900, GOS450, GOS900, and one control group consisting of untreated model wine. All four treatment groups underwent triangle testing against the untreated control, and one additional triangle test between the low and high concentrations of the respective oligosaccharide. After triangle tests, all four treatments, and the untreated control underwent descriptive analysis via 100mm visual analog scales. Panelists for the descriptive analysis panel underwent training on sweetness, bitterness, viscosity, acidity, and astringency prior to the beginning of the panel. The results of the triangle tests showed a significant different between the FOS450 and FOS900 samples. However, interestingly neither the FOS450 nor FOS900 samples were found to be significantly different from the untreated control sample. Additionally, neither of the GOS samples were found to be significant from either each other or the control sample. Descriptive analysis found no significant difference in any of the five attributes tested. This indicates that the difference between the FOS450 and FOS900 samples may be above a detection threshold but may not be above a perception threshold. This would mean that a difference can be noticed, but not quantified. Future work will investigate differing levels of oligosaccharides and implement more training to better differentiate during descriptive analysis.

DOI:

Publication date: September 24, 2021

Issue: Macrowine 2021

Type: Article

Authors

Samuel Hoffman, Elizabeth Tomasino, Quynh Phan,

Graduate Research Assistant and MS Candidate, Oregon State University, Associate Professor, Oregon State University Graduate Research Assistant and PhD Candidate, Oregon State University

Contact the author

Keywords

mouthfeel, wine, oligosaccharides, descriptive analysis

Citation

Related articles…

To a better understanding of the impact of vine nitrogen status on volatile thiols from plot to transcriptome level

Volatile thiols contribute largely to the organoleptic characteristics and typicity of Sauvignon blanc wines. Among this family of odorous compounds, 3-sulfanylhexan-1-ol (3SH) and 4-methyl-4-sulfanylpentan-2-one (4MSP) have a major impact on wine flavor. These thiols are formed during alcoholic fermentation by the yeast from odorless and non-volatile precursors found in the berry and the must. The effect of vine nitrogen status on 3SH and 4MSP in Sauvignon blanc wine and on the glutathionylated and cysteinylated precursors of 3SH (Glut-3SH and Cys-3SH) was investigated in this study.

Mobile device to induce heat-stress on grapevine berries

Studying heat stress response of grapevine berries in the field often relies on weather conditions during the growing season. We constructed a mobile heating device, able to induce controlled heat stress on grapes in vineyards. The heater consisted of six 150 W infrared lamps mounted in a profile frame. Heating power of the lamps could be controlled individually by a control unit consisting of a single board computer and six temperature sensors to reach a pre-set temperature. The heat energy applied to individual berries within a cluster decreases by the squared distance to the heat source, enabling the establishment of temperature profiles within individual clusters. These profiles can be measured by infrared thermography once a steady state has been reached. Radiant flux density received by a berry depending on the distance was calculated based on a view factor and measured lamp surface temperature and resulted to 665 Wm-2 at 7cm. Infrared thermography of the fruit surface was in good agreement with measurements conducted with a thermocouple inserted at epidermis level. In combination with infrared thermography, the presented device offers possibilities for a wide range of applications like phenotyping for heat tolerance in the field to proceed in the understanding of the complex response of plants to heat stress. Sunburn necrosis symptoms were artificially induced with the aid of the device for cv. Bacchus and cv. Sylvaner in the 2020 and 2021 growing season. Threshold temperatures for sunburn induction (LT5030min) were derived from temperature data of single berries and visual sunburn assessment, applying logistic regression. A comparison of threshold temperatures for the occurrence of sunburn necrosis confirmed the higher susceptibility of cv. Bacchus. The lower susceptibility of cv. Sylvaner did not seem to be related to its phenolic composition, rendering a thermoprotective role of berry phenolic compounds unlikely.

Selecting varieties best adapted to current and future climate conditions based on ripening traits

Aim: The aim of this study was to quantify key berry sugar accumulation traits and characterize their plasticity in response to climate variation from data collected from different cultivars over seven years from an experimental vineyard.

The grapesim model: a model to better understand the complex interactions between carbon and nitrogen cycles in grapevines

Nitrogen fertilization is an important practice to guarantee vineyards sustainability and performance over years, while ensuring berry quality. However, achieving a precise nitrogen fertilization to meet specific objectives of production is difficult. There is a lack of knowledge on the impact of nitrogen fertilizers (soil/foliar; organic/mineral) and different levels of fertilization on the interactions between carbon and nitrogen cycles within the vine. Crop models may be useful in that purpose because they can provide new insights of the effects of fertilization in carbon and nitrogen storage. The objective of this study is to build a model to simulate grapevine carbon and nitrogen content in vines to evaluate the impact of different fertilization strategies in vine growth and yield.

TOWARDS THE SHELF-LIFE PREDICTION OF OLD CHAMPAGNE VINTAGES DEPENDING ON THE BOTTLE CAPACITY

Today, nearly one billion bottles of different sizes and capacities are aging in Champagne cellars while waiting to be put on the market. Among them, several tens of thousands of prestigious cuvees elaborated prior the 2000s are potentially concerned by prolonged aging on lees. However, when it comes to champagne tasting, dissolved CO₂ is a key compound responsible for the very much sought-after effer-vescence in glasses [1]. Yet, the slow decrease of dissolved CO₂ during prolonged aging of the most prestigious cuvees raises the issue of how long a champagne can age before it becomes unable to form CO₂ bubbles during tasting [2].